top of page
  • How often should I have my watercraft serviced?
    It is recommended that you have your watercraft serviced every 6 months or after each season. An annual inspection by a qualified technician will also be useful to check the general condition and proper operation of the watercraft. Also, have the engine and important parts checked by a dealer every year or two. This will allow any malfunctions to be detected quickly and costly repairs to be avoided.
  • What are the common problems encountered with personal watercraft?
    Although it is relatively rare to experience problems with personal watercraft, some are more common than others. The main issues you may face include: poor combustion, low power, poor drivability, starting problems and oil leaks. More serious problems can also arise if the watercraft is not maintained properly or if the wrong parts are installed. Therefore, it is important to have regular inspections and maintenance by a qualified dealer to avoid these problems.
  • How do I know if my watercraft needs repairs?
    If you notice changes in the normal operation of your watercraft, it may be a sign that it needs repairs. Common symptoms include poor drivability, power losses, oil leaks, or a poorly running engine. If you notice any of these symptoms, it is best to have the watercraft inspected by a qualified dealer so that the necessary repairs can be made. In addition, it is important to have your watercraft serviced every 6 months or after each season to prevent problems from arising.
  • What are some general watercraft maintenance tips?
    To keep your watercraft in good condition, here are some general tips: - After each ride, clean the watercraft with fresh water and dry it completely with a towel. - Replace fluids (oil, coolant and fuel) as recommended by the manufacturer. - Regularly lubricate all pivot points and CV joints. - Have fluid levels and fuel pressure checked from time to time. - Regularly check the condition of all electrical connectors and wires. - Have the engine and important parts checked by a dealer, check the tension of the belts and have them replaced if necessary. - Remember to clean the air filter regularly, as excessive wear can lead to loss of power. - Replace worn and damaged parts immediately to avoid any unexpected issues while browsing. - Check bolts and other mechanical parts to make sure they are still tightened to the correct tension, and replace them if necessary.
  • Where can I take my watercraft to have it repaired?
    You can take your watercraft to an authorized dealer or specialized repair station for repair. Make sure the station is qualified and authorized by the manufacturer to perform repair and maintenance work on your specific model. In addition, you can seek advice or additional information from an experienced mechanic if you are having difficulty with your watercraft.
  • How often should I service my motorcycle?
    It all depends on your bike and how you use it. Manufacturers generally recommend an oil change every 3,000 to 5,000 km, although this figure can vary depending on the type of engine and the type of oil used. It's also important to check fluid levels and tire pressure every time you fill up.
  • What are common motorcycle repairs?
    Common motorcycle repairs include changing oil, replacing worn parts, checking brakes and clutch, cleaning air filter and carburetor, and replacing spark plugs. In the event of a more serious problem, such as an oil leak or a failed engine, it may be necessary to consult a professional mechanic. It is important to carry out these repairs in time to avoid more serious and costly problems in the future
  • How to change a motorcycle tire?
    Changing a motorcycle tire can be a complicated process and is best left to a certified technician. However, if there is no other choice, below are the steps for a successful tire change: - Raise your motorcycle. You can use a crutch or a jack. - Unscrew the bolts that hold the fender in place. - Remove the tire using a wrench or screwdriver and remove the tubes and valves. - Install the new tire, refit the tubes and valves. - Tighten the fender bolts and lower the motorcycle.
  • What oil should I use for my motorcycle?
    Most manufacturers recommend using synthetic motor oil for motorcycles, as it can provide superior performance and protection. Manufacturers usually offer specific oils for each vehicle, so it's important to check the owner's manual before buying oil. It's also important to choose a type of oil that suits your riding style and the region where you ride.
  • How do I prepare my motorcycle for winter?
    In order to prepare your motorcycle for winter, start by thoroughly cleaning the engine and the various components. Then check the tire pressure and replace them if necessary. Drain the fuel and refill the tank with fresh gasoline to prevent corrosion. Grease cables, joints and other moving parts for extra corrosion protection. Use a special antifreeze product for coolants and top them up to the recommended level. Finally, make sure all bolts and nuts are properly tightened. Keep your motorcycle out of the weather and under a tarp for protection. These simple measures will contribute to your peace of mind during the winter season.

Multi Mécanique Motorsport attend votre appel !

Multi Mécanique Motorsport est un atelier mécanique expérimenté et fiable qui se spécialise dans toutes les formes de services liés aux VTT. Notre équipe de mécaniciens certifiés a une connaissance approfondie des dernières technologies et peut s'attaquer à n'importe quel projet pour les besoins de votre véhicule hors route. Avec des prix compétitifs et des délais d'exécution rapides, nous nous engageons à assurer le bon fonctionnement de votre véhicule. Contactez-nous dès aujourd'hui pour en savoir plus sur nos services et remettez votre VTT sur les sentiers ! Nous sommes impatients d'avoir de vos nouvelles.

bottom of page